-40%
CAPACITOR KIT FOR VIZIO POWER SUPPLY EAX32241201 YPSU-J013A AAX30284301

CAPACITOR KIT FOR VIZIO POWER SUPPLY EAX32241201 YPSU-J013A AAX30284301

$ 8.98

  • Brand: VIZIO
  • Compatible Brand: For Vizio
  • Compatible Model: EAX32241201
  • MPN: YPSU-J013A
  • Type: CAPACITOR KIT
  • UPC: Does not apply
  • gtin13: Does not apply

Description

Warning! If you are not familiar with electronics, do not attempt to repair! This Repair Kit is directed to people with basic knowledge in electronics. M-tronicz TV Repair is offering this repair kit for a common failure in VIZIO EAX32241201 Power Supply Boards: Relay Clicking Shuts Down Unit powers up, but there is no display. Unit power on and off Dead Swollen electrolytic capacitors is an indication of capacitors that need to be changed but sometimes they can be bad without any outwardly visible signs. *************************************************************************************** Because not all of the boards fail in the same way, we do not guarantee that the components in this kit is all you need to fix your board but it can take care 90% off all cases. It's your responsibility to troubleshoot and properly diagnose your board in order to complete the repair. It is important to note that the above described behavior can be caused by a number of very different failures and not all of them could be related to this repair kit ! We recommend all kits fitted by a qualified personnel. A successful repair depends on the own skill and fault finding ability. This service kit is intended for use by persons having electrical, electronic and mechanical experience and knowledge at level generally considered acceptable in the consumer electronics and appliance repair trade. DOING YOUR OWN REPAIR WORK: The removal and replacement/installation of electronic components at the circuit board level is NOT recommended if you are not experienced with electronic component and circuit board repair. If you are new to this stuff, please take our advice and leave the work to a qualified expert- you will most likely thank yourself later. It is VERY easy to cause damage to electrical parts and circuit boards if repairs are not done with precision, neatness, and accuracy. It is very easy for one to make problems WORSE than they were before, if one does not know what one is doing, or does not have adequate experience with these kinds of parts and this kind of work in general.